Apply Vinyl Lettering Windex

If air bubbles occur puncture with a pin and smooth down.

Apply vinyl lettering windex.

Surface should be clean and dry before applying vinyl lettering. Peel off the wax paper using a friend to help with bigger decals. The vinyl will not stick as well to any oil or waxy surface. Apply water to the back side of the.

Do not use windex in an aerosol can. If there are larger areas with the adhesive we recommend spraying the area with windex and with a soft cloth that will not scratch the vinyl clean the area. Only remove the wax paper when you are ready to apply the decal to prevent dirt from getting on the adhesive surface. How to apply vinyl lettering racing stripes vinyl stickers vinyl decals pinstripes and more.

Spray the adhesive side of the decal with windex after or as you peel away the backing paper. Apply vinyl lettering to your surface lower the mask layer and using your squeegee press firmly at a 45 degree angle starting from the middle and going out. Peel the backing paper from the decal. Use the squeegee to squeeze out all the windex and air bubbles from underneath the decal.

Whether you are applying a small decal such as a college sticker or parking permit or adhering a large rear window graphic choosing the right tools in the best weather conditions and taking plenty of time will assure effective decal application. Apply rubbing alcohol to remove any remaining oils or waxes from the vehicle s surface. This is key and it s a good time to walk away from the car. The adhesive on the back of the vinyl lettering should stick well to your surface if it has been properly cleaned and prepped.

Use a little rubbing alcohol to clean the area where the decal will be applied. If you have never applied vinyl die cut decals it is recommend to do a little research online. The ammonia interferes with the adhesive. Such as metal glass plastic wood wall board etc.

There are many youtube videos and websites that have great tutorials on how to apply vinyl die cut decals. If you re applying the decal to glass do not use windex or other ammonia based cleaners. With some elbow grease the adhesive can be removed. They are all a little different but very helpful.

Remove the wax paper. Squeegee windex from under the decal beginning in the center and working outward. Vinyl can be applied to any smooth surface. Mild detergents or solvents can be used to remove wax grease tar etc.

Get the best results when applying car window decals by following expert tips. Final note the application of this vinyl decal requires a degree of dexterity and concentration.